Saniflo Water pump
| Motor |
Induction Motor |
| Motor RPM |
3600 |
| Horsepower |
0.3 |
| Electrical Supply |
110-115V; 60Hz |
| Flow rate at max head USG / MIN |
14 ft:18gal/min;3ft: 24gal/min |
| Amperage |
5.9 |
| Discharge Pipe Diameter |
1" diameter |
| Vertical Discharge |
14 ft |
| Horizontal Discharge |
140 ft |
| Gravity fall on horizontal installations |
1/4" per ft |
| Normal Running Time WC |
2-10 seconds |
| Maximum Temperature |
140°F |
| Dimensions (measured from floor level) |
H8-3/4" x W9" x D101/4" |
| Materials |
Polypropylene, C.R.P., stainless steel, Neoprene |
The Saniswift is a gray water pump that is ideally suitable for use in a
basement apartment or anywhere in the house where additional fixtures
are most wanted. It will pump the waste water away from a variety of
sources such as: a kitchen sink, laundry sink, washing machine
(indirect connection), dishwasher, bar sink, etc.
The inside of the Saniswift comprises of a pressure switch and circuit
board assembly, which starts and stops the unit, and the motor, which
drives the pump.
When the water enters the Saniswift, it activates a pressure switch
which in turn starts the motor. The motor is sealed for life in an oil filled
enclosure. A spindle/shaft drives the impeller and therefore the moving
parts are kept to an absolute minimum.
The unit pumps the effluent upward to 14 feet and/or 140 feet horizontally (with gravity fall). Once the water is discharged and the water level in the container goes down, the pressure switch deactivates the unit until water enters the unit again. A normal operating cycle for the Saniswift can be as short as 2 - 10 seconds depending upon the discharge pipe run configuration; power consumption is therefore minimal.